Keysight 81150A - Page 666

Appendix
666
Unsecure/Secure the instrument for calibration
:CALibration:SECure:STATe {ON|OFF}
Enter a new security code
:CALibration:CODE
Configure the FunGen’s internal state for each of the calibration steps to be performed
:CALibration:SETup[?]
Specify the value of the known calibration signal
:CALibration:VALue[?]
Query the instrument to determine the number of times it has been calibrated
:CALibration:COUNt?
Store a message in non-volatile calibration memory
:CALibration:STRing[?]
Trigger Model SCPI Commands
Falling/Raising edge of a trigger signal at the rear panel
:TRIGgger:SLOPe {POSitive|NEGative}
“Trig-Out” Connector
:OUTPut:TRIGger:SLOPe {POSitive|NEGative}
“Trig-Out” Connector
:OUTPut:TRIGger {ON|OFF}
Phase-Lock Commands
Adjust the Phase Offset
:PHASe[?] {angel}
Set the Zero Phase Reference
:PHASe:REFerence
On|Off of error reporting if phase-lock is lost
:PHASe:UNLock:ERRor:STATe {ON|OFF}