Keysight 81160A - Page 100

Appendix
100
Table Description
The table below shows which output functions are allowed with modulation,
sweep, and burst. Each “•” indicates a valid combination.
If you change to a function that is not allowed with modulation, sweep, or
burst, then the modulation or mode is turned off.
Sine
Square
Ramp
Pulse
Pattern
Noise
DC
Arb
AM, FM, PM
Carrier
•
•
•
•
•
FSK Carrier
•
•
•
•
PWM Carrier
•
Sweep Mode
•
•
•
•
Burst Mode
•
•
•
•
•
•
Front Panel
Operation
Press to output the arbitrary waveform currently selected. To view
the other arbitrary waveform choices, press the Select Waveform softkey.
To select dc volts from the front panel, press and then select the DC
Mode and then the DC softkey to enable/disable DC. Press the Offset
softkey to enter the desired offset voltage level.
Remote Interface
Operation
The following function is used to configure the output remotely:
:FUNCtion[1|2] {SINusoid|SQUare|RAMP|PULSe|NOISe|
DC|USER}
You can also use the APPLy command to select the function, frequency,
amplitude, and offset with a single command.