In the frequency sweep mode, the 81150A / 81160A “steps” from the start
frequency to the stop frequency at a sweep rate which you specify.
The 81150A / 81160A can produce a frequency sweep for sine, square,
ramp, or arbitrary waveforms (pulse, noise, and dc are not allowed).
Press to output a sweep using the present settings for frequency,
output amplitude, and offset. Enable sweep before setting up any of the
other sweep parameters.
The 81150A / 81160A will not allow the sweep mode to be enabled at the
same time when burst or any modulation mode is enabled. When you enable
sweep, the burst or modulation mode is turned off.
To Next Page
Loading...
