Keysight 81160A - Polarity

Appendix
124
3.2.16 Polarity
Introduction
In the normal mode (default), the waveform goes positive during the first
part of the cycle. In the inverted mode, the waveform goes negative during
the first part of the cycle.
Waveform Polarity
characteristics
 As shown in the examples below, the waveform is inverted relative to
the offset voltage. Any offset voltage present will remain unchanged
when the waveform is inverted.
 When a waveform is inverted, the Trigger Out and Strobe Out signal
associated with the waveform is not inverted.
Front-Panel
Operation
Polarity is available on the Function screens. Press the Polarity softkey
again to toggle between Normal and Inverted Polarity.
Remote Interface
Operation
The following function is used to configure the waveform polarity remotely:
:OUTPut[1|2]:POLarity {NORMal|INVerted}