Keysight 81160A - Idle Frequency

Features and Functions
81150A and 81160A User’s Guide 231
3.12.4 Idle Frequency
Introduction
Whenever the istrument is waiting for an active trigger edge or an active
gate signal, it outputs the idle frequency. The idle frequency can be set to
Start Frequency, Stop Frequency or DC (0 Hz).
Front-Panel
Operation
Press the or key to enable either Triggered or Gated mode.
Then press the key to reach the sweep screen.
Press the Idle Frequency softkey or use the navigation keys to select Idle
frequency.
Press the Idle Frequency softkey again or use the rotary knob to select from
Start Frequency, Stop Frequency, or 0 Hz (DC).
Remote Interface
Operation
:SWEep[1|2]:IDLE {SFRequency|EFRequency|DC}