Appendix
62
2.23 Selecting the Output Termination
The Keysight 81150A has a selectable series output impedance of either
50 ohms or 5 ohms to the front-panel output connector. If the actual load
impedance is different than the value specified, the displayed amplitude and
offset levels will be incorrect. The load impedance setting is simply provided
as a convenience to ensure that the displayed voltage matches the expected
load.
The Keysight 81160A has a fixed series output impedance of 50 ohms to the
front-panel output connector.
Press any
waveform screen
Press any of the waveform screens, i.e. Pulse, Sine, Square, Ramp, Noise or
Arb to adjust the output and load impedance.
Navigate the menu
to set the output
termination
Press the Load Impedance and Out Impedance softkeys to set the desired
values.
To Next Page
Loading...
