Keysight 81160A - IP Address (LAN)

Appendix
276
3.16.3 IP Address (LAN)
Introduction
An IP address is actually a four-byte integer expressed in the notation
"nnn.nnn.nnn.nnn" where "nnn" in each case is a byte value from 000 to
255.
You can enter an IP address for Keysight 81150A / 81160A.
Setting up an IP
Address
 You need not set an IP address if DHCP is in use.
 Contact your network administrator for a valid IP address to use for
your 81150A / 81160A.
 Enter the IP address using the numeric keypad (not the knob).
 The IP address is stored in non-volatile memory and does not change
when power has been off or after a remote interface reset.
Front Panel
Operation
 Press and then the I/O Interfaces softkey.
 Then select LAN, followed by IP Setup.
 By default, DHCP is On. Select DHCP Off if necessary. The IP
Address field appears.
 There is no SCPI command to set an IP address.