Keysight 81160A - 2.11 Selecting the Advanced Mode

Appendix
40
2.11 Selecting the Advanced Mode
Introduction
There are three advanced modes of operation available:
 Modulation
 Burst
 Sweep
These advanced modes are further explained below.
2.11.1 Modulation
Introduction
The following types of modulation are available:
 AM
 FM
 PM
 FSK
 PWM
To select
Modulation
Refer to Chapter 3, Features and Functions to understand how to select any
of these modulations.
 The 81150A / 81160A will allow only one modulation mode to be
enabled at a time. For example, you cannot enable AM and FM at the
same time. When you enable AM, the previous modulation mode is
turned off.
 The 81150A / 81160A will not allow any advanced mode to be
enabled with another advanced mode on the same channel.