EasyManua.ls Logo

Keysight 81160A - 3.6 Noise

Keysight 81160A
672 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Appendix
178
3.6 Noise
Introduction
Noise is specified by the following parameters:
Amplitude/Offset or High/Low Level
Probability Density Function (PDF)
Characteristics
The probability of seeing a specific output level can be defined by the PDF.
Gaussian distribution with a crest factor of 3.1
Gaussian distribution with a crest factor of 4.8
Gaussian distribution with a crest factor of 6.0
Gaussian distribution with a crest factor of 7.0
User defined distribution by the ARB waveform. In this case the waveform
defines how often a level will occur relative to all the others. The more often
a specific level appears in the waveform memory, the higher the probability
to see it in the generated noise signal.
Restrictions
Noise does not have the following parameters
Period
Frequency
Therefore, it has the following restrictions:
No modulation at all
No frequency sweep
No burst

Table of Contents

Related product manuals