Appendix
84
2.31.3 LAN Configuration
There are several parameters that you may need to set to establish network
communication using the LAN interface. Primarily, you will need to establish
an IP address. You may need to contact your network administrator for help
in establishing communication with the LAN interface.
Follow these steps to set the LAN address:
Select the “I/O”
Interfaces menu
Press and then press the I/O Interfaces softkey.
From this menu, you can select IP Setup to set an IP address and related
parameters, DNS Setup to configure DNS.
The Current Config is always displayed on the LAN screen.
LAN RESET does reset the LAN configuration back to DHCP/Auto-IP
and enables the web server.
To Next Page
Loading...
