Features and Functions
81150A and 81160A User’s Guide 277
3.16.4 Subnet Mask (LAN)
Subnetting allows the network administrator to divide a network into smaller
networks to simplify administration and to minimize network traffic. The
subnet mask indicates the portion of the host address to be used to indicate
the subnet.
You need not set a subnet mask if DHCP is in use.
Contact your network administrator to find out whether subnetting is
being used, and for the correct subnet mask.
Enter the subnet mask using the numeric keypad (not the knob).
The subnet mask is stored in non-volatile memory and does not
change when power has been off or after a remote interface reset.
Press and then the I/O Interfaces softkey.
Then select LAN, followed by IP Setup.
By default, DHCP is On. Select DHCP Off if necessary. Then select
Subnet Mask.
There is no SCPI command to set a subnet mask.
To Next Page
Loading...
