Keysight 81160A - Creating, Editing and Storing a Pattern

Features and Functions
81150A and 81160A User’s Guide 161
3.5.5 Creating, Editing and Storing a Pattern
Introduction
This section gives an example which shows you how to create, edit and
store a pattern from the front panel.
Create a New Pattern
Front Panel
Operation
After selecting the Edit Pattern softkey, press the Create New softkey.
Use this screen to modify the attributes of the new pattern and finally press
the EDIT softkey to reach the Pattern Editor screen as shown below:
Configure the new
pattern
Configure the new pattern by providing all the information shown in the
above screen. When done press the EDIT softkey to open the new created
pattern in the pattern editor.