Appendix
162
Remote Interface
Operation
:DIG:FORM PACKED,1
:DIG:DATA #2161001101001001001
Defines the initial number of bits in the pattern. For most efficient and
easiest editing, the desired pattern length should be chosen on this screen.
In case of setting up too less or too many bits here, this can be changed by
inserting or removing bits in the process of editing the pattern later on.
Defines the number of different levels or bit values in the pattern. This can
be set to 2, 3 or 4.
Defines the default bit value that is used to fill the pattern during creation.
Depending on the number of levels, the possible values are 0 and 1 for 2
level patterns. 0, 1 and idle for 3-level patterns. And, 0, 1, 2, 3 for 4-level
patterns.
On: Changes of the pattern will be applied immediately to the output. The
editor is slower.
Off: The pattern will be applied to output when editing is finished. The editor
is faster due to missing hardware update.
Edit a Stored Pattern
After selecting the Edit Pattern softkey, press the Edit Stored softkey to Edit
or Delete a stored pattern. This is shown in the following image.
Press the EDIT softkey to edit the selected pattern in the Pattern Editor,
which is described below.
To Next Page
Loading...
