Features and Functions
81150A and 81160A User’s Guide 265
3.15.4 Beeper Control
Normally, the 81150A / 81160A will emit a tone when an error is generated
from the front-panel or over the remote interface. You may want to disable
the front-panel beeper for certain applications.
The beeper state is stored in non-volatile memory and does not
change when power has been off or after a remote interface reset.
When shipped from the factory, the beeper is enabled.
Turning off the beeper does not disable the key click generated when
you press a front-panel key or turn the knob.
Press and then press the System softkey. Use the knob to
enable/disable the beeper.
Remote Interface
Operation
Issue a single beep immediately
SYSTem:BEEPer:STATe {OFF|ON}
Disable/enable beeper.
To Next Page
Loading...
