Keysight 81160A - Converting the Amplitude from One Unit to Another

Front-Panel Menu Operation
81150A and 81160A User’s Guide 47
2.13.1 Converting the amplitude from one unit to another
Introduction
You can easily convert the displayed amplitude from one unit to another.
For example, the following steps show you how to convert the amplitude
from Vrms to Vpp.
Enter the numeric
entry mode
To switch between different representations, press the amplitude, offset,
high level, low level softkey and then choose the different representation.
You can choose between High/Low, Ampl/Offs.
Select the new
units
Steps:
 Press Ampl softkey and then press the MORE softkey.
 This brings you to another menu layer where you can choose
between Vpp/Vdc, Vrms/Vdc, dBm/Vdc that will be used when
Ampl/Offs is selected. The same softkey menu provides easy
application of TTL and ECL level settings.