In addition to creating a new arbitrary waveform from the front panel, you
can also edit any existing user-defined waveforms. You can edit waveforms
that were created either from the front panel or from the remote interface.
However, you cannot edit any of the seven built-in arbitrary waveforms. And
only waveforms with a maximum number of 16384 points.
Press the Edit Waveform softkey to edit any of the arbitrary
waveforms stored in non-volatile memory or the waveform currently
stored in volatile memory. While editing an existing waveform, please
note the following interactions.
If you select an arbitrary waveform as the modulating waveshape for
AM, FM, PM, or PWM, the waveform is automatically limited to 16K
points. Extra waveform points are removed using decimation.
To Next Page
Loading...
