Keysight 81160A - Defining the Shape of a Bit

Appendix
614
7.4.4 Defining the Shape of a Bit
Introduction
The NRZ signals and the Arbitrary Bit Shapes are explained in this section.
NRZ Signals
Introduction
In NRZ mode, the transition times can be adjusted using the leading edge
parameter. The transition time defines the time it takes to move from one
signal level to the next one.
Transition times in NRZ mode are configured on the Pulse Screen using the
Leading Edge Parameter. The transition time is specified from 10% to 90% of
Amplitude. Refer to the Pulse Parameter Definitions
for more details.
NRZ mode with minimum
transition times
NRZ mode with transition
time = 1/3 * period
transition time
period
Max DAC
Min DAC
Data Pattern: 0 1 0 0 1 1 0 1