Keysight 81160A - Page 108

Appendix
108
Front-Panel
Operation
 To set the dc offset, press the Offset softkey for the selected
function. Then use the knob or numeric keypad to enter the desired
offset. To set the offset using a high level and low level, press the
Offset softkey again to toggle to the High and Low softkeys.
 To select dc volts, press and then select the DC On softkey.
Press the Offset softkey to set the desired offset voltage level.
Remote Interface
Operation
The following function is used to configure the DC Offset Voltage remotely:
:VOLTage[1|2]:OFFSet{<volts>|MINimum|MAXimum}
Or, you can set the offset by specifying a high level and low level using the
following commands.
:VOLTage[1|2]:HIGH {<volts>|MINimum|MAXimum}
:VOLTage[1|2]:LOW {<volts>|MINimum|MAXimum}
You can also use the APPLy command to select the function, frequency,
amplitude, and offset with a single command.