Keysight 81160A - Page 146

Appendix
146
Remote Interface
Operation
The following function is used to configure the Leading Edge remotely:
:PULSe:TRANsition[1|2]{<seconds
or
percentage>|MINimum|MAXimum}
:FUNCtion[1|2]:PULSe:TRANsition{<secondso
or
percentage>|MINimum|MAXimum}
The following function is used to configure the Trailing Edge remotely:
:PULSe:TRANsition[1|2]:TRAiling{<seconds
or
percentage>|MINimum|MAXimum}
:PULSe:TRANsition[1|2]:TRAiling:AUTO{OFF|ON|ONCE}
:FUNCtion[1|2]:PULSe:TRANsition:TRAiling:AUTO
{OFF|ON|ONCE}
It is used to set the automatic coupling of the pulse-trailing-edge transition
time to the leading-edge transition time.
 ON: The trailing-edge transition time is automatically set to the same
value as the leading edge and is updated automatically each time the
leading-edge transition time changes.
 OFF: The trailing-edge/leading-edge transition time is independently
programmable.
 ONCE: The trailing-edge transition time is set ONCE to the same
value as the leading edge.
The following function is used to set the unit for the remote programming of
the leading and trailing edge times.
:PULSe:TRANsition[1|2]:UNIT {S|SEC|PCT}
The following function is used to set the coupling between transition times
and the pulse width.
:PULSe:TRANsition[1|2]:HOLD {TIME|WRATio}