You can assign a custom name to the non-volatile memory locations.
The custom name can contain up to 12 characters. The first
character must be a letter but the remaining characters can be
letters, numbers, or the underscore character (“ _ ”).
To add additional characters, press the right-cursor key until the
cursor is to the right of the existing name and then turn the knob.
To delete all characters to the right of the cursor, press the
key.
For this example, assign the name “RAMP_AGT” to memory location 1 and
then press the STORE softkey to store the waveform. This will bring the
following screen.
Press Yes to overwrite the new Pattern Name on the existing old
name.
The pattern is now stored in non-volatile memory and is currently
being output from the 81150A / 81160A. You can select the storage
location by scrolling up and down in the list using the up/down
arrow keys or the knob.
The name that you used to store the pattern will now appear in the
list of stored patterns (under the Pattern Name softkey).
If you just change the name, you will effectively overwrite whatever has
been stored in this location before.
Store the pattern in VOLATILE memory in one of the internal, non-volatile
storage locations using the given name for the pattern.
:DIGital[1|2]:COPY <name>[,VOLATILE]
To Next Page
Loading...
