Keysight 81160A - Page 18

Appendix
18
What’s inside this
Chapter
The following topics are discussed in this section:
 The Front Panel
 Help is Available
 The Front-Panel Display at a Glance
 Menu Mode
 Graph Mode
 The Front-Panel Number Entry
 The Rear Panel
 Preparing the 81150A / 81160A for Use
 Using the Built-in Help System
 Selecting the Mode of Operation
 Selecting Trigger Mode
 Selecting the Waveform
 Selecting the Advanced Mode
 Setting the Output Frequency
 Setting the Output Amplitude
 Selecting Delay
 Selecting DC Volts
 Setting a DC Offset Voltage
 Setting the Duty Cycle of a Square Wave
 Setting the High-Level and Low-Level Values
 Configuring a Pulse Waveform
 Setting up a Pattern
 Viewing a Waveform Graph
 Outputting a Stored Arbitrary Waveform
 Selecting the Output Termination
 Outputting a Modulated Waveform
 Outputting an FSK Waveform
 Outputting a PWM Waveform
 Outputting a Frequency Sweep
 Outputting a Burst Waveform
 Triggering a Sweep or Burst
 Storing the Instrument State
 Configuring the Remote Interface
 Resetting the 81150A / 81160A