You can assign a custom name to the four non-volatile memory locations.
The custom name can contain up to 12 characters. The first character must
be a letter but the remaining characters can be letters, numbers, or the
underscore character (“ _ ”).
To add additional characters, press the right-cursor key until the cursor is to
the right of the existing name and then turn the knob.
To delete all characters to the right of the cursor, press the key.
For this example, assign the name “RAMP_NEW” to memory location 1 and
then press the STORE softkey to store the waveform.
The waveform is now stored in non-volatile memory and is currently being
output from the 81150A / 81160A. The name that you used to store the
waveform should now appear in the list of stored waveforms (under the
Select Waveform softkey).
To Next Page
Loading...
