Appendix
254
This softkey toggles between the Internal storage locations and the USB
mass memory.
This softkey is only available when you are working with USB memory.
Press the Change Directory softkey to navigate to the selected directory.
This softkey is only available when storing a waveform.
You can assign a custom name to the four non-volatile memory locations.
The custom name can contain up to 12 characters. The first character must
be a letter but the remaining characters can be letters, numbers, or the
underscore character (“ _ ”).
To add additional characters, press the right-cursor key until the cursor is to
the right of the existing name and then turn the knob.
To delete all characters to the right of the cursor, press the key.
This softkey deletes the currently highlighted waveform.
You cannot delete the built-in waveforms and the waveform in the Volatile
memory.
This softkey is only available when selecting stored waveforms for editing.
Pressing this softkey loads the selected wavform into volatile memory and
opens the waveform editor to edit the volatile memory.
Only waveforms of upto 16K points can be created/edited using the Front
Panel interface. Larger waveforms must be edited using an external
application, such as Keysight BenchLink Waveform Builder, and then
downloaded into the 81150A / 81160A.
To Next Page
Loading...
