Keysight 81160A - Page 298

Appendix
298
 Burst
Factory Setting
Burst Count
2 Cycle
Burst Start Phase
0 degrees
Burst State
Off
 Triggering Operations
Factory Setting
Trigger Mode
Continuous
Trigger Source
External-In
Internal Trigger Frequency
100 KHz
Triggered/Gated by
Rising Edge/High Level
System-Related Operations
Factory Setting
*Power-Down Recall
Enabled
Display Mode
On
Error Queue
Errors are cleared
Stored States, Stored Arbs
No Change
Remote Interface Configuration
Factory Setting
*GPIB Address
*10
*DHCP
*On
*IP Address
*0.0.0.0.
*Subnet Mask
*0.0.0.0.
*Default Gateway
*000.000.000.000
*DNS Server
*000.000.000.000
*Host Name
*agtXXXXX (where XXXXX stands for the instrument’s serial
number)
*Web Server
*Enabled
*Web Server Password
*AGT81150 (81150A only)
*Keysight (81160A only)
Parameters marked with an asterisk are stored in non-volatile memory.
Parameter groups marked with a  will be part of the stored instrument state. The content of the
volatile arb memories is not part of a stored instrument state.