Keysight 81160A - Page 376

Appendix
376
Command
:AM[1|2]:INT:FREQ[?]
Long
[:SOURCE]:AM[1|2]:INTernal:FREQuency[:CW|:FIXed]
[?]
Parameters
{<NR3>|MINimum|MAXimum}
Parameter Suffix
HZ
Description
Set the frequency of the modulating waveform. Used only when the Internal
modulation source is selected (AM[1|2]:SOUR INT command). The
AM[1|2]:FREQ? query returns the internal modulating frequency in
Hertz. It doesn’t apply if “INT2” is selected.
Example
:AM1:INT:FREQ 8MHZ