Remote Programming Reference
81150A and 81160A User’s Guide 417
Output Commands
:OUTput[1|2][:NORMal][:STATe][?]
Disable or enable the corresponding front-panel Output connector. The
default is “OFF”. When the output is enabled, the corresponding key is
illuminated on the instrument’s front panel. The OUTP[1|2]? query
returns “0” (OFF) or “1” (ON).
The APPLy command overrides the current OUTP command setting and
automatically enables the Output connector (“ON”).
If an excessive external voltage is applied to the front-panel Output
connector, an error message will be displayed and the output will be
disabled. To re-enable the output, remove the overload from the Output
connector and send the OUTP[1|2] ON command.
To Next Page
Loading...
