Keysight 81160A - Page 438

Appendix
438
Command
:FUNC[1|2]:PULS:HOLD[?]
Long
[:SOURce]:FUNCtion[1|2]:PULSe:HOLD[?]
Parameters
{WIDTh|DCYCle|TDELay}
Parameter Suffix

Description
Set instrument to hold either pulse width or pulse duty cycle or trailing
delay:
WIDTh
The instrument holds the pulse width setting (in seconds)
constant as the period is varied. (Minimum width and edge
time restrictions apply.)
If a command to set a duty cycle value is received, the duty
cycle is converted to the equivalent pulse width in seconds.
If Pulse Width Modulation (PWM) is turned on, the pulse
width is held, and the width deviation also is held, as the
period is varied. Duty cycle deviation commands are
converted to width deviation values.
DCYCle
The instrument holds the pulse duty cycle setting (in
percent) constant as the period is varied. (Minimum width
and edge time restrictions apply.)
If a command to set a pulse width value is received, the
width is converted to the equivalent duty cycle in percent.
If Pulse Width Modulation (PWM) is turned on, the pulse
duty cycle is held, and the duty cycle deviation also is held,
as the period is varied. Width deviation commands are
converted to duty cycle deviation values.
TDEL
The instrument holds the trailing delay setting (in seconds)
constant as the period is varied. (Minimum width and edge
time restrictions apply.)