Keysight 81160A - Page 440

Appendix
440
Command
:FUNC[1|2]:PULS:TDEL[?]
Long
[:SOURce]:FUNCtion[1|2]:PULSe:TDELay[?]
Parameters
{<NR3>|MINimum|MAXimum}
Parameter Suffix
S
Description
Set the delay of the trailing edge of the pulse relative to start of pulse
period. This is an alternative method of programming pulse width.
 This command is affected by the :PULS:HOLD[1|2] command, which
determines the value to be held constant as the period is adjusted: the
specified pulse width value, or the specified pulse duty cycle value, or
specifies the trailing delay. See the :PULS:HOLD[1|2] command for
further information.
Example
:FUNC2:PULS:TDEL 50.8NS