LAN
The instrument’s network settings are managed by the internal instrument
software and the connected network environment. You can press the Utility
key at the front panel, select I/O interface -> LAN using the instrument’s
softkeys to get the network setting. The default setting for DHCP (Dynamic
Host Configuration Protocol) is ON. Contact you network administrator if you
need help in defining your own instrument’s IP address.
GPIB
To connect to the generator via GPIB you have to have the instrument’s
GPIB address. To see the address on the display press the Utility key at the
front panel, select I/O Interface using the instrument’s softkeys. The default
address is 10. When setting the GPIB address, it is recommended that you
do not use the GPIB address 21. This address is reserved for a GPIB
controller.
USB
The generator has a device type USB port on the rear panel for remote
programming. This is the non-flat USB port close to the LAN connector. To
connect to the instrument via USB, you need the instrument’s USB ID. If the
instrument’s USB port is connected to a computer via an adequate USB
cable a dialog will pop up automatically. This dialog generated by the
Keysight IO Library Suite shows the USB ID. You can either use the full VISA
resource string or assign an alias. See the Keysight IO Libraries Suite
documentation for details.
To Next Page
Loading...
