238 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Error Messages
Error Messages (Alphabetical Order)
-
O
47 OPEN measurement incomplete
This error occurs when the cable correction OPEN measurement is incomplete.
-321 Out of memory
The E4981A has insufficient memory to perform the requested operation.
P
1080 Power failed
Power unit hardware failure is detected.
Contact Keysight Technology’s Sales and Service Office or the company from
which you purchased the device.
-108 Parameter not allowed
The number of parameters is larger than required by the command. For
example, although the :CREJ:LIM command requires one parameter such as
“:CREJ:LIM 3”, two parameters are added to give “:CREJ:LIM 0,3”.
-112 Program mnemonic too long
The length of the header exceeds 12 characters. (Refer to IEEE488.2,7.6.1.4.1.)
Q
-350 Queue overflow
The queue contains a certain code other than the code that caused this error.
This indicates that an error has occurred due to insufficient space in the queue
but has not been recorded.
-400 Query error
A comprehensive Query error has occurred for which the E4981A cannot detect
further details. This code simply indicates the occurrence of a Query error that
is defined in IEEE488.2,11.5.1.1.7 and 6.3.
-410 Query INTERRPUTED
This indicates the status that causes an “INTERRUPTED” Query error. (Refer to
IEEE488.1,6.3.2.3.) This error occurs, for example, when data byte (DAB) or
GET is received after Query but before the response has been completely sent.
-420 Query UNTERMINATED
This indicates the status that causes an “UNTERMINATED” Query error. (Refer
to IEEE488.2,6.3.2.) This error occurs, for example, when the E4981A is
specified as a talker and an incomplete program message is received.
To Next Page
Loading...
