Keysight E4981A - Page 43

Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 43
Getting Started
Learning Basic Measurement Procedure
Setting up cable length
Select the length of the measurement cable from 0 m, 1 m, or 2 m, depending
on the test set lead you use.
0 m When you do not use the test lead (in other words, when you
connect the test fixture directly to the UNKNOWN terminal).
1 m When you use the Keysight 16048A/B test lead.
2 m When you use the Keysight 16048D test lead.
The procedure used to set up the length of the measurement cable is described
below.
Step 1. Press the [Meas Setup] key.
Step 2. Press the CORRECTION softkey.
Step 3. Use the cursor keys to select the CABLE field.
Step 4. Use the following softkeys:
Figure 3-7 Cable length selection menu screen
Softkey Description
0 m Sets the cable length to 0 meter.
1 m Sets the cable length to 1 meter.
2 m Sets the cable length to 2 meter.