Keysight E4981A - Page 42

42 Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter
Getting Started
Learning Basic Measurement Procedure
3-
Setting up measurement signal level
Set up the voltage level of the signal applied to the DUT (capacitor) during
measurement.
Step 1. Press the [Display Format] key.
Step 2. Press the MEAS DISPLAY softkey.
Step 3. Use the cursor key to select the LEVEL field.
Step 4. Use the softkeys or entry keys to enter the test signal level. When data is
entered with the entry keys, the softkeys change to units labels (mV, V).
Figure 3-6 Measurement signal level setup screen
Softkey Description
INCR++ Increments the oscillator voltage level in steps of 100 mV, 500 mV,
1 V.
INCR+ Increases the oscillator voltage level with a resolution of 10 mV.
DECR- Decreases the oscillator voltage level with a resolution of 10 mV.
DECR-- Decrements the oscillator voltage level in steps of 1 V, 500 mV,
100 mV.