Keysight E4981A 120 Hz/1 kHz/1 MHz Capacitance Meter 57
Setting up Measurement Conditions and Display
Selecting Measurement Range
Selecting your desired measurement range (hold range)
The selectable measurement ranges are shown in Table 4-3. As this table
shows, selectable measurement ranges differ depending on the measurement
signal frequency. Therefore, if a newly selected measurement frequency
conflicts with the current measurement range setting, the setting is
automatically changed to cover the allowable range.
The procedure to set up the measurement range mode is described below.
Setup procedure
Step 1. Press [Meas Setup].
Step 2. Use the cursor key to select the RANGE field.
Step 3. Use the numeric keys or following softkeys:
Table 4-3 Selectable measurement ranges
For 120 Hz measurement
signal frequency:
For 1 kHz measurement
signal frequency:
For 1 MHz measurement
signal frequency:
1 pF 2.2 pF 4.7 pF
10 pF 22 pF 47 pF
100 pF 220 pF 470 pF 100 pF 220 pF 470 pF
1 nF 2.2 nF 4.7 nF 1 nF
10 nF 22 nF 47 nF 10 nF 22 nF 47 nF
100 nF 220 nF 470 nF 100 nF 220 nF 470 nF
1 µF 2.2 µF 4.7 µF 1 µF 2.2 µF 4.7 µF
10 µF 22 µF 47 µF 10 µF 22 µF 47 µF
100 µF 220 µF 470 µF 100 µF
1 mF
Softkey Description
AUTO Sets the measurement range mode to AUTO.
HOLD Sets the measurement range mode to HOLD.
INCR+ Increments the measurement range in the HOLD mode.
DECR- Decrements the measurement range in the HOLD mode.
To Next Page
Loading...
