Kinematic Matrix 2360 - Specifications

Matrix 2360 Programmable Shear User Manual - Section 1
12-092600 A 3
1.4 Specifications
• Throughput
3
.................................. up to 360 strips per minute in strip mode
• Strip/Card Length:
Strip Mode
4
...................................... 0.8 mm to 19.00 mm (0.03” to .75”)
Card Mode ................................... 19.01 mm to 609.00 mm (0.76” to 24”)
• Cut Tolerance:
Strip Mode .................................................................... 0.10 mm (0.004”)
Card Mode .................................................................... 1.52 mm (0.060”)
• Width of Material ......................... min 19.05 mm (0.75”), max 101.6 mm (4")
Stretch model ...................... min 57.15 mm (2.25”), max 152.4 mm (6”)
• Weight (approx.) ..................................................................... 37 kg (80 lb.)
Stretch model (approx.) ...................................................... 39 kg (85 lb.)
• Dimensions (approx.) ........ 45.7 cm x 43.2 cm x 29.2 cm (18” x 17” x 11.5”)
Stretch model ........... 45.7 cm x 48.3 cm x 29.25 cm (18” x 19” x 11.5”)
(Dimensions do not include optional roll feed equipment)
• Mounting ............................................. Tabletop with vibration-damping feet
• Facilities Requirements:
Power: Voltage ........ 100-120VAC, 50/60Hz (or 207-244VAC, 50/60Hz)
Current (FLA Full Load Current).............. 1.23 Amp (0.62 Amp)
Current (SCR Short Circuit Rating) ................................... 5 kA
• Environment:
Temperature Range (Operating) .................... 1° to 30° C (33° to 85° F)
(Storage) ............................................... -25° - 55 °C (-13° - 131 °F)
Humidity ................................................................ 10% to 30% at 30° C
Altitude ................................................................... up to 2000m (6562’)
• Noise Level ........................................................................... less than 70 dB
3
If feature registration is used, the maximum speed will be reduced.
4
Minimum strip width is dependent on material being cut.