Matrix 2360 Programmable Shear User Manual - Section 3
14 12-092600 A
3.7 General Safety Notes
DO NOT DEPEND on the automatic safety systems. Activating the EPO switch or
other safety interlock does not disconnect dangerous voltages within the machine.
ELECTRICAL HAZARD: Before working on the machine, or
working inside the electrical cabinet, main power should be
disconnected at a source external to the electrical cabinet.
If a condition occurs that requires operator intervention within the processing area of
the machine, first observe that the machine is fully stopped. Turn the electrical power
off at the power entry module on the rear of the system. When reaching into the
process area, be careful of any hazards. The system, although protected by adequate
safety covers, may have various pinch points, cutting points, and electrical shock
hazards exposed while performing service or repairs.
To Next Page
Loading...