Matrix 2360 Programmable Shear User Manual - Section 4
12-092600 A 15
4 INSTALLATION
The Matrix™ 2360 Programmable Shear is a stand-alone system requiring only
connection to the proper power source for operation.
The Matrix™ 2360 Programmable Shear is designed for use in a controlled
environment. Although designed and constructed to withstand even the most
adverse of manufacturing atmospheres and demanding applications, the machine is
a very precisely adjusted, sensitive piece of machinery. ‘Unnecessary roughness’
during transportation and installation should be avoided. The Matrix™ 2360
Programmable Shear should be treated like any fine instrument, with care and
attention, and only by those who understand its value.
The unit should have been shipped completely assembled. Save the packing crate
for storage and/or shipping.
4.1 Moving the Machine
The Matrix™ 2360 Programmable Shear is small and light enough to be carried
without the use of a forklift or other lifting device. It is recommended that two
persons lift the machine by its base.
IMPORTANT: Do not lift the equipment by the top components,
control panel, or optional roll feed.
A rigid stand, bench, or table should be cleared and ready for machine placement
before the machine is moved. Gently place the unit on the tabletop.
Suggested Clearance: Approximately 1 m (3’) on all sides.
4.2 Storage
Keep the original shipping crate for long-term storage and or shipping. This will
protect the machine from damage. Shipping it in a different container will result in
additional charges if you return the unit for service. Keep storage temperature in the
range of -25 to 55 °C (-13 to 131 °F).
To Next Page
Loading...