Matrix 2360 Programmable Shear User Manual - Section 3
12-092600 A 11
1) Check the machine to ensure that nonessential items have been removed
from the clearance space around the machine and that the machine and its
components are operationally intact.
2) Verify that the electrical power switch is off (‘O’) above the plug receptacle.
3) Remove the lock out / tag out devices.
4) Reattach the power cord to the plug receptacle on the machine.
5) Turn the electrical power on (‘|’) with the switch above the plug receptacle.
6) Test the operation of the equipment.
7) Notify affected employees that the servicing or maintenance is completed and
the machine or equipment is ready for use.
3.3 Vision & Hearing Safety
Wear protective glasses while operating or working around the
equipment. There is a risk of flying projectiles due to the blade
moving at high speed.
is less than 70 dB(A). Hearing protection is not required.
3.4 Other Personal Protection Equipment Requirements
This equipment may be used to process materials treated with a variety of
substances, some may be hazardous to the skin or lungs. The safety precautions
required vary greatly depending on the chemical(s) used. The following equipment
may be required. Consult the safety information in the MSDS for the chemicals
used on the material that will be processed with this equipment.
Wear protective gloves designed to protect hands from sharp
edges while cleaning the shear blade.
Also, wear protective gloves while handling material treated with
any hazardous substance. Refer to the MSDS for information
about the chemicals used in your process.
The sound levels indicated here were measured at the Kinematic facility. Sound levels may vary at
the final location.
To Next Page
Loading...