Matrix 2360 Programmable Shear User Manual - Section 7
12-092600 A 65
Make complete side to side passes with the stone until there is no resistance.
This pushes the burr to the far side of the blade.
13. Turn the
blade back
over and hold
the white
ultrafine
Arkansas
hard stone
parallel with
the work
surface.
Make
complete side
to side
passes with
the stone
until there is
no resistance. This pushes the burr back to the flat side of the blade.
14. Repeat steps 12 and 13 until the burr peels off. When the burr is almost
gone, the white Arkansas hard stone can be used at a slight angle to remove
the last traces of the burr.
15. Test the sharpness by drawing the edge of
a strip of paper along the sharpened edge.
The edge should cut the paper smoothly
without tearing it.
16. When the blade sharpening process is
done, dust off the blade and then wipe it
with a soft cloth and denatured alcohol.
Dry the blade before beginning the
reassembly.
NOTE: Before reassembling the blade is a good time to inspect
the die block and clean the rollers. See Section 7.11.
To Next Page
Loading...