1 - 10
This illustration shows the D32E-1
INTRODUCTION SERVICE INFORMATION
GENERAL
Instructions contained in this shop manual are for information and guidance of
the service personal who are responsible for the overhaul and repair of this
machine. In this shop manual, the use of the terms left, right, front and rear
must be understood to avoid confusion when following the instructions. These
terms indicate the sides of the machine when facing forward in the operators
seat. Due to a continuous program of research and development, some proce-
dures, specifications and parts may be altered in a constant effort to improve
this machine. Some illustrations are of a general application and may not show
the component parts accurately in all details.
PIN AND SERIAL NUMBERS
The PIN (product identification number) is stamped on a plate attached to the
right hand side of the dash support on the engine side. It is also stamped on the
right rear face of the rear main frame in the upper corner. The engine serial
number is on a plate on the left side of the engine front gear cover above the
fuel pump.
To Next Page
Loading...
Need help?
General
