12 - 2
POWER ENGINE
STANDARD VALUE TABLE FOR ENGINE - D32E AND D32P
Machine models D32E-1/P-1
Engine model 4D102E-1
Item Measurement condition Unit Service limit value
Standard value for
new machine
Engine speeds ‚ Low idle 830 to 1030 830 to 1030
‚ High idle 2650 to 2780 2650 to 2780
RPM
‚ Rated speed 2500 2500
Intake air restriction full throttle max. 508 (12)
‚ At torque converter stall and
‚ At restriction indicator port
mm H O
2
(in H O)
2
New
element
305 (12)
Used
element
508 (20)
Lubricating oil pres-
sure with SAE 15W-
40 oil & coolant tem-
perature in operating
range
‚ Minimum at low idle 70 (10) 70 (10)
kPa *
(psi)
‚ Minimum at high idle 207 (30) 207 (30)
kPa *
(psi)
Fuel filter inlet ‚ Maximum restriction at high
restriction idle
mm Hg
(in Hg)
100 (3.9) 200 (3.9)
Blow-by pressure ‚ Service Tool orifice size 25 (1) 50 (2)
‚ Coolant temperature in op-
erating range:
• 5.613 mm (0.221 in)
‚ Full load at rated speed
mm H O
2
(in H O)
2
Exhaust back pres- ‚ Maximum at converter stall
sure and full throttle
mm Hg
(in Hg)
76 (3.0) 76 (3.0)
Coolant temperature 100 (212) 100 (212)
‚ Maximum coolant operating
temperature
EC (EF)
Valve clearances
with engine cold
‚ Intake valves 0.25 (0.010) 0.25 (0.010)
mm (in)
‚ Exhaust valves 0.51 (0.020) 0.51 (0.020)
* To determine kg/cm² from kPa, divide (÷) kPa by ten.
p For further detailed information, refer to Engine Shop Manual.
To Next Page
Loading...
Need help?
General
