TRANSMISSION COUNTERSHAFT
7C - 56
2. Install 3rd speed gear (2).
3. Install retaining ring (5) to top groove in countershaft.
4. Heat bearing cone to 135EC (275EF) for 45 minutes. Install on
shaft and bottom. To insure cone is seated, keep pressure
against cone until it cools.
5. Turn countershaft over. Install retaining ring (5).
6. Install 2nd speed gear (3) on countershaft against retaining ring.
7. Install 1st speed gear (4) on countershaft against 2nd speed
gear.
8. Heat bearing cone to 135EC (275EF) for 45 minutes. Install on
shaft and bottom. To insure cone is seated, keep pressure
against cone until it cools.
To Next Page
Loading...
Need help?
General
