7-22
Using Finisher Manually
This function is available only with the Cover Sheet Feeder option (PI-108) installed on
the FS-111/211 Finisher.
To use this convenient function, simply place a set of paper into the cover sheet feeder,
select the desired mode from the Manual Finishing operation panel located on the top
of the Finisher, then press the Start/Stop button.
Available finishing modes according to the optional configuration are described below.
FS-111 Finisher + PI-108 Cover Sheet Feeder
• 1 oblique staple
• 2 parallel staples
FS-211 Finisher + PI-108 Cover Sheet Feeder
• 1 oblique staple
• 2 parallel staples
• Stitch & Fold (2 staples in the centre + Fold)
FS-211 Finisher + PI-108 Cover Sheet Feeder+ TU-108 Trimmer Unit
• 1 oblique staple
• 2 parallel staples
• Stitch & Fold and Trimming (2 staples in the centre + Fold + Trimming)
>>>Specifications for Manual Staple 1 oblique staple and 2 parallel staples<<<
❒ Paper size: A3, B4, F4, A4, A4R, B5, A5
❒ Paper weight: 60 ~ 90 g/m
2
paper
❒ Staple capacity: 50 sheets max. (80 g/m
2
paper)
❒ Output tray: Primary (main) tray
>>>Specifications for Manual Stitch & Fold mode<<<
❒ Paper size: A3, B4, A4R
❒ Paper weight: 60 ~ 90 g/m
2
paper
❒ Staple capacity: 20 sheets max. (80 g/m
2
paper)
19 sheets max. (80 g/m
2
paper with a thick paper cover)
❒ Output tray: Booklet tray
>>>Specifications for Manual Stitch & Fold and Trimming mode<<<
❒ Paper size: A3, B4, A4R
❒ Paper weight: 60 ~ 90 g/m
2
paper
❒ Staple capacity: 16 sheets max. (80 g/m
2
paper)
15 sheets max. (80 g/m
2
paper with a thick paper cover)
❒ Output tray: Trimmer unit tray
To Next Page
Loading...
