Selecting Paper Size (continued)
3-13
To Specify Desired Paper Size (AMS)
When a paper size is specified on the touch screen, an appropriate reduction or
enlargement ratio will be selected automatically according to the original size detected
from the RADF or the platen glass.
HINTS
• See the table on the following page for the relation of original size, copy
paper size, and magnification ratio automatically selected.
• Wide paper size can be specified when AMS is in use.
In this case, the same magnification ratio as that of the standard size will
be selected automatically.
• If copying in 1.00 (100%) magnification mode and specifying a paper
size, see p. 3-15.
1. Touch a tray key on the Basic Screen to select the desired paper size.
Selected tray key will be highlighted, and under the LENS MODE AMS indication will
also be highlighted.
2. Select additional copy conditions, as desired.
3. Enter the desired print quantity from the control panel keypad.
HINT
See p. 3-7 for details on setting print quantity.
4. Position original(s).
HINTS
• See p. 11-8 to p. 11-10 for paper sizes detectable from the RADF or on
the platen glass.
• See p. 3-2 to p. 3-6 for details on positioning originals.
5. Press [START].
Scanned image will be printed on the specified paper size using an automatically
selected magnification ratio.
DETAILS
Copy result may not be satisfactory due to the Rotation function. In this
case, turn the function OFF manually. See. p. 7-4.
3
Copying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Paper Size
Lens Mode
Density
1-2, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
FS-111/211
Output Modes
Binding
Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
To Next Page
Loading...
