3-15
Selecting Magnification Ratio (Lens Mode)
When the copier is turned ON, the magnification ratio is set to 1.00 (100%) automatically
on the Basic Screen.
Follow each procedure described in this section to select the desired magnification
ratio.
To Copy in 1.00 Magnification Mode
Follow this procedure to make a 100% copy of the original image.
1. Close the RADF securely, then press [AUTO RESET].
The initial settings are restored. Check that APS is highlighted to indicate that the 1.00
magnification is selected.
HINT
The initial settings may be altered by the Key Operator. See p. 13-10 to p.
13-11.
2. Select additional copy conditions, as desired.
DETAILS
Specifying paper size will release 1.00 magnification and set
AMS
automatically.
In this case, touch
1:1
to highlight it again.
3. Enter the desired print quantity from the control panel keypad.
HINT
See p. 3-7 for details on setting print quantity.
4. Position original(s).
HINT
See p. 3-2 to p. 3-6 for details on positioning originals.
5. Press [START].
3
Copying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Paper Size
Lens Mode
Density
1-2, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
FS-111/211
Output Modes
Binding
Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
To Next Page