[9] Weekly Timer (continued)
13-35
[5] Timer Interrupt Password Setting
Use this password setting mode to establish a 4-digit password requirement for using
Timer Interrupt function.
The default password of 0000 allows the timer function to be interrupted without the
requirement for password entry.
Weekly Timer Setting Menu Screen Timer Interrupt Password Setting Screen
Procedure
1 Touch [9] Weekly timer on the Key Operator Mode Screen.
Enter your 4-digit Weekly Timer master key code, then touch OK to display the Weekly
Timer Setting Menu Screen.
NOTE:
If an invalid Weekly Timer master key code is entered, continue by entering
the valid 4-digit code.
2 Touch [5] Timer interrupt password set to display the Timer Interrupt Password
Setting Screen.
3 Use the touch screen keypad to enter a 4-digit password, and then touch OK to
complete the setting and return to the Weekly Timer Setting Menu Screen.
NOTE:
When the password setting is 0000, timer interrupt can be used simply by
turning the copier OFF, then ON. In this case, you will be asked to enter the
duration of use (a period of time to turn the copier power on).
4 Touch PREVIOUS SCREEN to restore the Key Operator Mode Screen.
5 If no further changes are required, touch PREVIOUS SCREEN to restore the Basic
Screen to perform copying operations.
13
Key Operator
Mode
Non-Image
Area Erase
Scan
Transmission
Centring
Adjustment
Timing
Adjustment
HDD
Management
Finisher
Adjustment
Side 2 Lens
Adjustment
Call Remote
Centre
Machine
Management
List Print
Memory
Switch
Power Save
Setting
Tray Auto
Select Setting
Control Panel
Adjustment
Weekly
Timer
Key Operator
Data Setting
Panel Contrast/
Key Sound
Paper Type/
Special Size
Lock/Delete
Job Memory
E.K.C.
User Setting
Mode
Copier Initial
Setting
System Initial
Setting
Key Operator
Mode
To Next Page
Loading...
