13-10
[2] Copier Initial Setting
Initial settings are the settings that display automatically when the copier is powered on,
when Auto/Reset timer is operated, or when [AUTO RESET] key is pressed. These
settings can be changed by the Key Operator, as shown in this section.
Initially (i.e., at installation), the Basic Screen displays the following conditions to meet
Energy Star requirements:
Initial Setting
Copy Mode : 1-1
Copy Density : AE
Lens Mode : 1:1
Paper Tray : APS
Output Mode : offset sort
When Initial settings are changed by the Key Operator, the new initial settings display
when the copier is powered on, when Auto/Reset timer is reached, or when [AUTO
RESET] key is pressed.
The following initial settings can be changed by the Key Operator:
Copy mode : [RADF; 1-1; 1-2; 2-2; 2-1]
Copy density : [AE; manual]
Lens mode : [AMS; ratio 0.25~4.00]
Paper tray : [APS; trays 1, 2, 3, or LCT]
Output mode : [Non-sort; Sort, Group; Staple-sort; Stitch&Fold; Fold;
Punch; Trimming; Cover sheet]
Special original : [Original Direction; Text/Photo Enhance; Special Original;
Original Form]
Rotation : OFF
Setting procedures are described on the following pages.
NOTE:
The most commonly-used settings are established at installation. Before
changing any of the copier settings, be sure that you understand the overall
and long-range effect of the change.
Key Operator Mode Screen Copier Initial Setting Screen
To Next Page