Positioning Originals (continued)
3-5
Positioning originals in SDF mode
In the SDF mode, one thick original can be fed through the RADF original tray.
HINT
• To use the SDF mode, see procedure on p. 8-10 to p. 8-11.
• For the SDF original specifications, see p. 11-10.
1. Adjust paper guides to the SDF original size.
Reminder!
• Before placing the SDF original in the tray, be sure the paper guides are
adjusted correctly; otherwise the SDF mode may not function properly.
• Be sure not to use unsuitable RADF originals. See p. 11-8 for details.
2. Insert an original FACE UP in the document feeder tray.
Insert two-sided original with page one FACE UP.
The original will be fed and scanned automatically.
3
Copying
Operations
Positioning
Originals
Setting Print
Quantity
Set Job During
Warmup
Stop
Scan/Print
Paper Size
Lens Mode
Density
1-2, 2-2
2-1
Multi-Sheet
Bypass Tray
Using
Memory
Output without
Finisher
FS-111/211
Output Modes
Binding
Mode
Recalling
Previous Job
Check Mode
& Proof Copy
Interrupt
Mode
To Next Page