Making Single-Sided Copies from Double-Sided Originals (2
1)
3-28
4. Enter the desired print quantity from the control panel keypad.
HINT
See p. 3-7 for details on setting print quantity.
5. Position originals FACE UP in the document feeder according to the
original direction specified in step 2.
HINTS
• See p. 3-2 to p. 3-6 for details on positioning originals.
• Use RADF store mode (p. 3-32 to p. 3-33) when the original count
exceeds 100.
6. Press [START].
The machine starts to scan originals, then prints simplex copies when ready for output.
Press [STOP] to suspend the scanning or printing job.
CAUTION
When the finisher / trimmer unit / paper exit tray capacity is
exceeded due to the print quantity selected, remove the copied
sets as they exit; otherwise, mishandled paper will occur.
To Next Page