252
Media edit mode
Save
Saving a single bank
You can save a single User bank with a single operation. A bank
corresponds to a button on the control panel of the instrument
(i.e. a button of the STYLE section).
1. If saving to an external device, connect the device to one of
the USB Host ports.
2. The full content (“All”) of the internal memory is already
shown. Select it, and touch Open to open it. A list of User
data types appear (each type is a separate folder).
3. Select the folder containing the type of data you wish to
save, and touch Open to open it. The list of contained
banks is shown.
4. Select the bank to be saved, and touch Save To to confirm
the selection. The list of files of the target device is shown.
5. If needed, select a different target device, by using the
Device pop-up menu. When the target device is selected, its
content will appear in the display.
6. At this point, you can:
• Touch the New SET button and create a new “.SET” folder
(see “Creating a new “.SET” folder” on page 253), or
• Select an existing “.SET” folder, and touch Save to con-
firm.
7. A dialog box appears, asking you to select one of the avail-
able User (or Favorite Style) locations inside the folder:
In the above dialog box, the previously selected bank of
Styles will be saved to the bank User 01 (corresponding to
the USER1 button) inside the selected folder. Three User
banks are available.
8. Touch OK to confirm, or Cancel to abort.
Warning: After confirming, the same bank in the target folder
is deleted.
Saving a single item
You can save a single User item with a single operation.
1. If saving to an external device, connect the device to one of
the USB Host ports.
2. The full content (“All”) of the internal memory is already
shown. Select it, and touch Open to open it. A list of User
data types appear (each type is a separate folder).
3. Select the folder containing the type of data you wish to
save, and touch Open to open it. The list of contained
banks is shown.
To Next Page
Loading...
Need help?
General
