71
Singing with a connected microphone
Connecting a microphone
Quick Guide
4 Go to the main page of the Style Play or Song Play mode, and select the
Mic tab. Be sure the Mic input is not muted.
5 Sing into the microphone, and adjust the input gain and the Microphone
volume, until you achieve the correct settings.
Note: You have a cor-
rect microphone volume
setting when the AUDIO
IN LED stays green most
of the time. The AUDIO
IN slider must be set
accordingly, to compen-
sate a too loud or weak
incoming signal.
6 Press the EFFECT and HARMONY buttons to turn their LED on, and acti-
vate the Voice Processor.
7 Try the Play/Mute button of the Microphone panel, to mute/unmute the
whole microphone section.
Note: This is the
same play/mute control
you can find in the “Mic/
In” channel strip of the
Volume panel.
8 Touch the Volume tab to select the Volume panel.
Mic panel. To test the
microphone level, be
sure the Mic Mute,
Effects and Talk buttons
are unchecked.
i
ASSIGNABLE SLIDER
SLIDER MODE
ASSIGN. B
ASSIGN. A
MIC
AUDIO IN
Adjust the input level by using the GAIN knob next to
the AUDIO INPUT 1. Sing into the microphone, and
watch at the AUDIO IN LED on the control panel – it
ought to stay green. If it goes orange too often (or
even red), turn down the input gain; if it turns off too
often, increase the input gain. No hint of distortion
should be heard in the audio system when you sing.
While you adjust
the gain, gradually
increase the Micro-
phone volume, by
using the corre-
sponding slider.
i
Microphone muted Microphone set to
play
To Next Page
Loading...
Need help?
General
